|
Hand Sifter 1L
WaterSavr Spreading Solution - Less than 2.5 Acres (1 Hectare)
Easy, inexpensive application by a single person is achieved with a household flour sifter
Direction for use:
- Weigh the correct amount of WS for the surface area of the water to be treated, place the WS in the sifter and mark the level so that weighing şs done only once.With vareful weighing and labeling, a single sifter can be used for many water bodies at a general site such as a farm or golf course.
- The correct amount is 1 pound per acre or kilogram per hectare every 2 days.
- Application can also be done as 1/2 pound per acre or 1/2 kilogram per hectare daily
- Sift the Ws onto the water surface from yhe upwind side of the water storage only, being sure apply some of the powder at every point along the upwind edge where access is possible. If there is no wind, apply at 3-5 points along the most accessible edge.
Safety
- Keep closed except when in use
- Keep dry and out of any direct sun
- Keep below 30 degrees Celcius or 80 Fahrenheit
- Secure product awy from unauthorized personnel
The M-60 Automatic
WaterSavr Spreading on 50 Acres (20 Hectares) or Less
For water bodies up to 50 acres (20 hectares) use the automatic M-60 machine
Capacity: 135Ibs (60kg) of WaterSavr
Power Source: 12-volt battery
Charging System: Pholovoltaic panel maintains full charge
Refill Period: Every Seveb days on 50 acre (20 hectare) reservoir.
Direction for use:
- Place machine in the water at the upwind side of the reservoir close to the center of the upwind side or the side that is most often upwind if there is no wind at the at the set-up time.
- Fill the hopper with WS using proper safety precautions.
- Fix the anchor line to the shore line and place the anchor the full line length out from shore.
- Set the timer for the day, hour and run time for the surface area using the timer instruction sheet.
- Push "on"
- Pull on the appropriate portion of the line until the machine maximum distance from shore.
- Bote time and date for next refill according to surface area being treated.
Safety
- Wear a dust mask and safety glasses.
- Wear gloves or wash with soap and water immediately after applying.
Storage
- Keep closed wxcept when in use
- Keep dry and out of any direct sun
- Keep below 30 degrees Celcius or 80 Fahrenheit
- Secure product away from unauthorized personnel
The JV-225
Watersavr Spreading Larger than 50 Acres (20 Hectares)
Multiple JV225's in the flotilla can service surfaces to 100,000 acres and more.
Capacity:500 Ibs (225kg) of WaterSavr
Power Source: liquid fuel combustion engine
Crew Size: 2
Treatment area per hour: 150 acres (60 hectares)
Dispensing Time: 3hours 20 minutes per 500 Ibs (225kg) load
Direction for use:
- Secure the platform to a boat of sufficient size
- Mount the pump on the platform with the outlet clamped to the stern and just below water line when moving at application speed.
- Load the desired number of 50 Ibs WS bags low but dry in boat
- Position the crew with access to the WS bags, the intake wand and clear access to the pump controls.
- Proceed the designated start point
- Engage pump, insert wand into first WS vag and distribute as the steersman begins the designated application route.
- Disassemble and clean the venturi after every use
Safety
- Wear a dust mask and safety glasses.
- Wear gloves or wash with soap and water immediately after applying.
- Never dispense WS into the wind or in front of the boat.
Storage
- Keep closed except when in use
- Keep dry and out of any direct sun
- Keep below 30 degrees Celcius or 80 Fahrenheit
- SEvure product away from unauthorized personnel
Choosing the right applicator for WS
ACK sells 3 different applicators for Watersavr.
- Hand Sifter
- M-60 automatic
- JV-225 (boat mounted, not automatic)
The fibal cois of applicator will depend on site-spesific conditions, however, the basic logic for choosing one system over the others is a sound starting point.
The sifter is very inexpensive. It takes a single person less than 10minutes to treat a hectare (2,5 acres). If the water body to treated, is small and geographically close by, the sifter is the best coise as long as personnel is available, reliable and inexpensive. Examples include golf courses, housing developments and irrigation ponds close to operations center of a farm. Poor choices for a sifter ate water bodies larger than a hectare, furher from regular operations than five minutes and high wage costs or low employee compliance. If any of these symptoms are present, consider the M-60.
The M-60 is automatic and has a payload of 60 kg (135 Ibs), equal to five PJ-12s.
It is also designed for remote locations. One M-60 can treat a maximum of 20 hectares when the refill schedule is once a week. Compared to five PS-12s, one M-60 Simplifies the refill process. The M-60 can also be used in multiples, for example five M60s can service 100 hectares (250 acres) or can be programmed to extend the refill cycle on fifty hectares (125 acres) to two weeks from one. It is the best choice for remote use up to 100 hectares.
The JV-225 is not automatic and it requires a boat and to person crew. Howeve, it compensates by the ability to treat very large areas in a short time and by its extraordinary simpicity.This is only realistic choice for water surfaces larger than 100 hectares (250 acres) and should be considered for surfaces greater than 20 hectares if the water body is not remote and reasonably paid personnel is available.
In conclusion; choose the right system by assessing surface size, remoteness, wages and price. Consult the WaterSavr sales team şf you wish an upinion or recımmendation.
|
Application Methods
